|
.png)
ABOUT US
With over 25 years of experience manufacturing Estia Appliances, we have some of the best manufacturing skills South Africa has to offer.
Why GAP
- GAP is a recognized brandname.
- Manufacturing company has been in existence for 30 years.
- We are an eco friendly company.
- GAP offers competitive pricing.
- GAP provides slimline geysers, made to fit easily into ceilings.
- All GAP geysers are SABS approved.
- GAP offers backup service and spares.
- The element and thermostat are situated low down on the boiler to ensure a quick and lasting heating process.
- The process of enamel is done by a barelling method, resulting in an even distribution.
CLASSIC GEYSER
Features
- Element and thermostat positioned low down to ensure a quick and lasting heat process.
- Each boiler pressure tested before and after enamelling.
- Boilers are visually inspected after enamelling to ensure proper coating.
- Boiler body made from 1.6mm enamel quality steel while domes are deepdrawn from 2mm enamel quality steel.
- Boilers are designed to operate at 400 KPA water pressure and fitted with a magnesium alloy anode.
- Boilers fitted with SABS approved elements and thermostats.
- Vitreous enamel is used on the inside of each boiler.
- Casement rolled from 0.6mm galvanised sheeting and insulated from boiler with polyurathane foam for minimum heat loss.
- Geyser supplied with a drain cock and 400 KPA safety valve.
- BSP female sockets machines from EnB steel.
- All geysers are of the IPX1 type (fitted indoors or under cover).
1. Electric Element.
2. Thermostat.
3. Anode.
4. Pressure Valve.
5. Drain Cock.
6. Safety Valve (T.P Valve).
7. Enamel Lined Tank.
8. Flange Rubber Gasket.
9. High Density Insulation.
10. Drip Tray.
11. Drain Tray Overflow.
12 .Vacuum Breaker.
13. Galv. Outer Casement.
ECO GEYSERS
features
Savings of up to 25%
Double Polyurethane Insulation
Special Stainless Steel Element
Fully Waterproof
The spiralling cost of electricity has necessitated a careful examination of our existing design of domestic hot water geysers. One of the greatest sources of energy wastage in any hot water geyser is overnight standing heat loss. It takes approximately 7,68 kWh and 10,24 kWh respectively to heat 150L and 200L of water by 45°C (15°C to 60°C).
The SANS 151 code for 150L and 200L for fixed electric storage water heaters states that standing heat loss cannot exceed 2,59kWh or 3,02kWh respectively per 24hr period. In order to conform to this requirement most locally manufactured geysers are insulated with a 25mm layer of polyurethane foam.
For the new ECO range of 100L, 150L and 200L geysers the insulation has been increased to 50mm as independent surveys have shown that by doubling the thickness of the geyser insulation (between the inner tank and outer skin) will result in the geyser standing heat losses decreasing by over 20%.
Kitchen Units and Appliances
     
|
